A Cycling & bikes forum. CycleBanter.com

Go Back   Home » CycleBanter.com forum » rec.bicycles
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Techniques Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Brooks - Conquest & Flyer saddles by Andrew Price
Hallo Folks, I've looked long and hard in the group archives, but can't find any information to distinguish between the Brooks Conquest and Flyer. Is it...
August 13th 05 09:38 AM
by Andrew Price Go to last post
0 266
Spoke Gauge vs Wire Gauge by G. Huang
Is there a difference between wire gauge and spoke gauge? In electric wire for example, AWG12 always means 2mm (actually 2.05mm). When I went to get some...
August 13th 05 09:13 AM
by A Muzi Go to last post
3 460
Can't true my wheel (roundness) by chrisc
I got the side to side down. But when I work on the roundness, I can't get it right. The wheels only have about 800 miles on them. I trued them according to...
August 13th 05 08:59 AM
by A Muzi Go to last post
6 354
Ritchey Freehub / Campy/Shim cassette mount question by Hank Wirtz
Bob wrote in : I know next to nothing about freehubs... so I have a basic...
August 13th 05 07:36 AM
by Hank Wirtz Go to last post
0 174
Stupid MTB vs. Road Bike frame sizing question by RonSonic
On Wed, 10 Aug 2005 06:26:21 GMT, Bob wrote: Stupid question: In general, if you are building an MTB/rough surface bike where you...
August 13th 05 02:23 AM
by Lee Go to last post
1 182
Cannondale CAAD 8 2005 by HSP
Hello Anyone using this frameset ? I need opinions (ride quality, reliability, handling) Thanks
August 12th 05 10:57 PM
by Gooserider Go to last post
4 698
saddle repair by [email protected]
covered at: 'Recover your ugly saddle, Patching Small Hole in Leather Saddle' -in bike.tech archives plus one i cannot find the goop saving idea is a good...
August 12th 05 10:30 PM
by [email protected] Go to last post
1 167
MKS rubber pedals - where to buy? by dan_s
i'm looking for an upgrade of pedals for my 3-gear raleigh. the original's bearings are wildly loose and are not repairable afaik. i'd like to buy the MKS type...
August 12th 05 05:07 PM
by maxo Go to last post
1 219
Supplier for 20mm Vulcanizing patchs? by Tom Nakashima
Looking for a supplier for 20mm vulcanizing tube patches (patches only), either Rema or Parks. The LBS used to carry them, but only sells the larger patches...
(Multi-page thread 1 2)
August 12th 05 02:45 PM
by Tom Nakashima Go to last post
13 468
Campy 10 speed upgrade problem by [email protected]
I had some Daytona 9 speed shifters, Racing T cranks, and a Racing T rear derailleur. I got some new Chorus 10 speed shifters, a Centaur 10 speed cassette,...
August 12th 05 01:34 PM
by Qui si parla Campagnolo Go to last post
7 308
Velomax wheels folding in. by Callistus Valerius
I saw a few weeks ago, someone saying they have started seeing Velomax wheels that arn't durable enough. Which models, if this is true? Or anyone, that has...
August 12th 05 01:08 PM
by Qui si parla Campagnolo Go to last post
4 155
Do I need a new tire? by David Crist
My front tire has developed a series of cracks where the side wall starts to round over to the running surface. Should I replace this tire? What causes this?...
August 12th 05 11:05 AM
by Dale Benjamin Go to last post
5 121
Roller brakes: running friction? by [email protected]
Shimano says the following about their roller brakes: "Inter-M brake is different from conventional brakes in that the inside of the brake drum is filled with...
(Multi-page thread 1 2 3)
August 12th 05 09:57 AM
by Dan Gregory Go to last post
24 384
Manitou EFC Spring replacement kit by db
Does anyone know were i might find a spring replacement kit for Manitou EFC. Needed for retro Yeti build. have tried theese with no joy...
August 12th 05 09:45 AM
by db Go to last post
0 317
Long-reach dual-pivot brakes: Different mechanical ratios across different makes? by Mykal
Now comparing two makes of long-reach (57 mm) dual-pivot brake calipers, I notice the two have a differing geometry that may translate to...
August 12th 05 09:08 AM
by Luns Tee Go to last post
9 444
Recommendation for 700c x 42-45 tire for light off-road (fire roads,light trail use) by SMS
I want a set of off-road tires for my Trek T100 tandem, for light trail and fire road use. It's a "cross" tandem, with 700c rims that I measured as 20mm wide,...
August 12th 05 06:26 AM
by A Muzi Go to last post
9 1,582
Water in rims? by [email protected]
Hi, It's been raining a bit lately and my rims seem to be permanently full of water. Any suggestions on ways to get rims to empty after rides in the...
August 12th 05 06:19 AM
by Mike Jacoubowsky Go to last post
8 230
New Realizations by [email protected]
I have changed my ways. I do not believe that "Fretting" occurs, it is all a lie. Square taper bottom brackets are far superior to anything on the market today...
(Multi-page thread 1 2)
August 12th 05 02:25 AM
by [email protected] Go to last post
13 250
Knee Pain ...again by E Willson
I have been riding about ten miles a day for the last three years. I have not changed the setup on my bike for the last two years, and have had no problems...
August 12th 05 01:13 AM
by Mister2u Go to last post
3 161
Keith Bontragers on 31.8 handlebars by Llatikcuf
Did anyone else see this? Sorry, it's kind of long. From: http://www.cyclingnews.com/tech.php?id=tech/2004/features/bontrager - - - - - - - - - - - - - - - -...
August 12th 05 12:13 AM
by Llatikcuf Go to last post
1 184
Post New Thread

Display Options
Showing threads 20001 to 20020 of 25947
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT +1. The time now is 12:25 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright 2004-2019 CycleBanter.com.
The comments are property of their posters.