Hi Folks, I'm poised to buy a bent for my daily commute of 12.5 miles, but not sure whether to go for a quasi low racer or a tourer type. I currently commute...

New, 2004 T-Bone 700c x 700c recumbent,Terra Glide Flex stem bar, FSA headset, SRAM rocket shifters, DuraAce triple front derailleur, XTR rear derailleur,...

My dreams of living without a car have come to an abrupt end after less than three months because of a job change. I have a nearly brand new B.O.B. Ibex...

This is the steel version http://www.boomspeed.com/papasbent/MyBeaterBent.jpg http://www.boomspeed.com/papasbent/MyBeater.jpg Wheelbase: 65" Weight: ...

Larry Varney Wrote: Cough, nudge, wink, ahem.-- Larry Varney Cold Spring, KY http://home.fuse.net/larryvarney Larry who? --

wheel dr Wrote: Have to agree with Gabe about the presumption. I'm sure that some of the GRR/Ti Rush crowd I rode with last weekend would welcome you and...

Yes, I am fully bent. I bought the Cycle Genius RDX. That's the good news. I put a handlebar-end mirror on it and went for a ride. Getting off, my left knee...

I know RANS was doing beta testing on a seat mod to make it more comfortable. Does anyone know if the mods really work? We have a Screamer and my stoker is off...

If you're wandering around the supermarket magazine aisle, take a look at the latest (September) issue of Outside magazine. On page 20 there's a two-page...

Hi Any of you folks using airless tires? Can you recommend a company? Thanks

I like this guy already http://www.bikecomedy.com/modeldriver.aspx?linkkey=photos

Expand your stationary cycle workout by joining it with a speed bag. Here is how to do it. http://www.speedbagcentral.com/Tips_UniqueWorkoutss.html#B See...

I ride mountain bikes a lot and am very familiar with hydraulic disc brakes. Most current systems are "open", or have a fluid expansion reservoir at the...

Look for the fat guy with the beard, on a blue EZ-1 and wearing the jersey of the North Florida Bicycle Club and say Hi. Bill, riding bent in Florida (hence...

Hi All, I entered the local senior Olympics and did my first training ride this morning. I ran out of steam after 3 miles as I was pushing it pretty hard.I'm...

My recumbent is bent. It got rusty one morning. Y -no Muffler tubes are not stainless. I ate three old bikes to make it, But had not fifty dollars for a...

I just purchased a Catrike Road and the bike shop didn't have any mirrors that would fit. Does anyone know of a mirror that will fit the bars of a Catrike in...

FS: Kevlar fairing for Rotator Pursuit It is about 5 or 6 years old and in good condition. Very low miles with only minor cosmetic issues. Its in good...

A few months ago the seat on my TE developed a creaking noise. I tried everything I could think of to cure the problem. Checked to see if the hose clamps were...

Yo, Benters: My wife and I will be once again riding the High Sierra Fall Century just east of Mammoth, Ca. This is a fantastic ride that I cannot recommend...