Hi, I want to go fixie for my daily commute! I'm tempted by a cheap Fuji track bike (about =A3300) which seems to be quite popular for road use. Does anyone...

Hi If you are looking for some plastic parts to be made in low cost, we can help you. http://www.aaaok.co.uk At least 50% cheaper than normal manufacturers

Actually, a internal-hub chain but I'm assuming that's the same thing functionally. I read Sheldon's take at http://www.sheldonbrown.com/chains.html. Sounds...

Hello, A while back I picked up a lot of older drivetrain goodies at a sports store closeout ($1 each for chains, bottom brackets, cassettes, etc..). I'm...

Hello, Can anyone offer a timeline or explanation of the different Cinelli handlebars that were made? Typically, I see something like '66-40' where 40 is the...

Hello All! I have just got a new Scott MC20. The first time I rode it, I noticed that the outside of the chain rubs against the derailleur cage but only when...

I'm having a Bike Friday built up. I'm going to be using a Ultegra triple crank. The smallest chainring that I can use is 33 tooth. If I try to use a smaller...

Looks like the new trigger system from SRAM has some results in the Pro races, but I was wondering what the feedback from normal riders has been - searched...

Reading a thread on metabolism and bicycle riding I wanted to know a little about fat metabolism, so I looked for some articles on the WWWeb. Some excerpts...

(PeteCresswell) wrote: Road bike or mtb w/hp slicks, flat pavement, no wind, just cruising along at that certain speed where you're comfortably within...

There's a new chain for sale (patents pending) by this company which consists entirely of half links: http://www.theshadowconspiracy.com/main.html (flash...

does it degass over time? hehe don't laugh corvettes degass and there's considerabble hand wringing over here! is it handmade or does it pop out of a...

allow me to reccomend campmor's trail mail for winter riding clothing bargains and the performance duofold t-rides cool but stopped at 120 degree surface...

I'm moving an old set of fenders to a new bike and need to replace the wire used to mount the fenders. Any suggestions on how to source this? I could replace...

Hi everyone, I have an old (mid 80s) Cannondale road bike which wobbles noticably when I coast, or when I lift the rear wheel and spin the cranks by hand. The...

A while back I installed a set of Mr Tuffy's - the worst thing ever invented. They cut my tubes. Recently a club member said that the Spin Skins were...

All - Thanks to the insight of the people, I went to Sears & purchased a torque wrench. Now I need a listing of suitable torque values. Is there a...

Greetings, I was looking for Clips that fit on the seat-rail of my saddle so I could connect a Carradice Bag. I want to transfer the bag from one bike...

THE ANSWER! to chain tool pin control the answer is-drill a small hole into the chain tool's surface below and to the right of the pin's passage to the...

Has any of you used Oil Eater for bike and bike chain cleaning? In what dilution rate? See http://www.oileater.com/ Is it good? Sam's Club has it now for a...