Octalink V2 crank bolt question: Washers needed on both sides?
Just removed a shot BB and when taking off the bolts from the cranks I
found that the left side had a thin washer but the right side did not. Weird. The crank set is Shimano FC-M522. Is a washer needed on both sides? Is it steel? If so I'll probably have to make one. -- Regards, Joerg http://www.analogconsultants.com/ |
Octalink V2 crank bolt question: Washers needed on both sides?
On 2018-02-12 15:27, Joerg wrote:
Just removed a shot BB and when taking off the bolts from the cranks I found that the left side had a thin washer but the right side did not. Weird. The crank set is Shimano FC-M522. Is a washer needed on both sides? Is it steel? If so I'll probably have to make one. Well, I just made a washer for the other side. -- Regards, Joerg http://www.analogconsultants.com/ |
All times are GMT +1. The time now is 09:53 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
CycleBanter.com