John Meerse wrote:
Looking for a pair of sealed bearings for a front Suntour Superbe pro
hub, from 1995-1996.

Sheldon Brown wrote in message
...
These are standard industrial bearings


"dianne_1234" wrote in message
om...
Weren't Superbe Pros those unusual kind of precision bearing where the
cone still screwed onto the axle? I think SunTour Cyclone hubs had
actual cartridge bearings as Sheldon describes, but the Superbe Pros
I've taken apart are not the same.

1992 was the last season of full production. In the 1992 book, Superbe Pro
and XC Pro are listed as using cartridge bearings "for the first time" but
the bearing size is not listed.
After removing the axle, just measure the bore and outer case with a caliper
if you cannot read the number on the seal.
--
Andrew Muzi
www.yellowjersey.org
Open every day since 1 April, 1971