On Tuesday, September 15, 2020 at 4:22:33 PM UTC-7, Mark Cleary wrote:
On Tuesday, September 15, 2020 at 6:09:26 PM UTC-5, jbeattie wrote:
On Tuesday, September 15, 2020 at 2:29:01 PM UTC-7, Mark Cleary wrote:
On Tuesday, September 15, 2020 at 12:52:21 PM UTC-5, wrote:
Op dinsdag 15 september 2020 om 18:50:35 UTC+2 schreef :
These are tubeless compatible do they have traditional spoke access holes?
Deacon Mark
yes.

Well more questions. I used the DT Swiss spoke calculator and input the hubs dimensions that I measure myself to make certain. It is a basic Novotec f842sb hub. According the the calculations it says 282 for DS and 287 for NON DS. That seems to be more than usual of 2 mm difference. I am sure of my measuring does that seem reasonable to have 5mm difference?

Deacon Mark
IIRC, its around 281/282 3X NDS on a Shimano Ultegra hub with the DT460s. You're numbers are way off unless that Novatec is a high-low flange hub, and even if it were, it would have to have a really low NDS. Could you send us a link to the hub. Those numbers don't pull anything up.

-- Jay Beattie.
2 cross my rim my bad

Deacon mark

I don't know the hub but suspect the spoke calc is wrong because of some input error. I could see getting that kind of length disparity on a high-low hub or a hub with different cross-patterns side to side like 3X DS and 2X NDS.

-- Jay Beattie.