On 8/18/2019 11:09 PM, AK wrote:
On Sunday, August 18, 2019 at 9:28:59 PM UTC-5, Frank Krygowski wrote:
On 8/18/2019 10:11 PM, AK wrote:
On Sunday, August 18, 2019 at 8:25:40 PM UTC-5, John B. Slocomb wrote:
On Sun, 18 Aug 2019 17:35:54 -0700 (PDT), AK
wrote:



The opening in the hex screw that holds the rear brake cable has become much looser than it used to be. What is the name of the part so I can order another one? (Hopefully they have some made of harder steel.)

https://imgur.com/a/JT76Qog

It is simply a clamp bolt and the question is whether it holds the
brake cable tightly when it is tightened, If it does than I shouldn't
worry about it.

As the bolt should be clamping the cable between a flange or washer on
the bolt and the brake arm itself. When it is tightened it shouldn't
move at all.

Your picture looks a bit strange, but maybe it is the perspective. See
https://sheldonbrown.com/canti-direct.htmlto
from a slightly different angle.
--

Cheers,

John B.

If that clamp bolt gets enlarged much more so my hex wrench slips, it will definitely be a big problem.

Are you positive you're using the correct size hex wrench? Some people
mistakenly grab a U.S. (inch) wrench and use it on metric screws that it
_almost_ fits.


--
- Frank Krygowski

The bike is a Huffy Nighthawk Model 56347. The manual does not specify whether it uses American or metric sizes.

I have just a set of American hex wrenches but could get a set of metric wrenches and see if one of them fits the clamp bolt better.

Andy


It's made in China with all metric fasteners.

--
Andrew Muzi
www.yellowjersey.org/
Open every day since 1 April, 1971