View Single Post
  #16  
Old November 13th 17, 05:22 PM posted to rec.bicycles.tech
Frank Krygowski[_4_]
external usenet poster
 
Posts: 10,538
Default Alfine 11 hub skipping under hard pedaling

On 11/13/2017 4:04 AM, JQ wrote:
On 11/10/2017 8:50 AM, wrote:
Dear All,

Thank you for your comments and advice. I investigated a little more
and I have isolated the skipping to the 8th gear. It only happens
after pedaling for a while so it is hard to replicate on a stand. Now,
every time it happens, I change the adjustment a little and experiment
with the frequency of the skips.

Also, as you suggested, I need to change the oil. The Shimano or
Rohloff oils are ridiculously expensive, so I have found this
alternative at a reasonable price:

Liqui Moly 1401 GL4 SAE 80 W Transmission Oil

For about $10 per quart it will allow me to rinse the hub more than
once and more change the oil. What do you think?

Many thanks again

Dimitris

https://www.amazon.de/gp/product/B004FPQYW4/



On Tuesday, September 26, 2017 at 3:22:34 PM UTC+2, dstamat wrote:
Dear All,

The Alfine 11 SG-S700 hub of my commuting bicycle has started to skip
when I pedal standing up. Mostly around the middle of the range (5, 6
and 7). I hear a very loud noise and I have to stop pedaling. It does
not happen when pedaling seated. When in 6 gear the two small yellow
lines are aligned so I guess it is not because of bad adjustment.


I have had this bike for ~5 years but it has only been ridden for
~1000 mi. The oil of the hub has not been changed yet.

Any ideas?

Thanks in advance

Dimitris

I would think the gear that is skipping is the one you ride in mostly,
right? If it is the case the chain has stretched and the gear teeth has
also stretched, so when it is under heavy load the instead of the chain
sitting in the chain groove it is slipping up and out.Â* causing the hops
or skips. Start saving up your money to replace both the chain and
cassette. You will be able to get many more miles but you will need to
start avoiding the gear that is slipping. Keep the chain clean and lubed
and the cassette clean to get the most out of it. A new or newish chain
may give you better performance but I would not put a new chain on there
until you switch out everything. Get a decent chain and cassette and
definitely don't go with the lightest one around as they will not last
as long. Good luck and safe riding...


The Shimano Alfine 11 is an internal gear hub. It has only one sprocket.
The problem must be internal. And it's a pretty complicated beast.
See https://www.sheldonbrown.com/alfine-11.html

That article has some discussion of slipping problems.

--
- Frank Krygowski
Ads
 

Home - Home - Home - Home - Home