well, have the thread cutting tool in place before you cut, assuming that it
is a 'die' tool, so that when you rethread after cutting to the CORRECT
length and SQUARE you are able to thread without making a mess.

the $20.00 LBS sounds good.

tony f" wrote in message
...
On Sun, 10 Aug 2003 22:35:53 +1000, "Dallas Goldburg"
@au wrote:

BEFORE you cut make sure you thead on the top headset so that AFTER you
cut
you can unthread it and then use it

Likely to be threadless style these days - not always, mind you, but
threadless is the current "standard" for mtb forks. Dallas is still
right for threaded forks, I just think the Judy TT will be threadless.

Tony F
www.thefathippy.com