drill/tap in frames
On 13/07/18 15:30, John B. Slocomb wrote:
On Fri, 13 Jul 2018 00:10:02 +0200, Emanuel Berg
wrote:
James wrote:
Then you should definitely not just drill
and tap the frame tube itself.
Why not?
The material is too thin.
Is it more thick at the bottom of the bottom
bracket shell and at the bottom-mid section of
the down tube where I have seen this numerous
times, and also the chainguard stays to the
chainguard intersection?
A bottom bracket is usually specified as 7 - 8 mm thick.
Not even close.
--
JS
|