On 2017-11-11 18:13, John B. wrote:
On Sat, 11 Nov 2017 10:39:42 -0800, Joerg
wrote:
On 2017-11-11 07:51, jbeattie wrote:
[...]
... Avid uses a
higher torque spec. 5nm should be plenty to keep your stem and
headset tight, but probably not in Cameron Park.
It does but only if I smear some grit-laden toothpaste on the fork tube
before sliding on the stem. Not the paste for electric brushing but the
regular paste. What I am saying is that 5nm feels like it's about to
strip the aluminum threads out.
I think I'd buy a torque meter. And use it :-)
Trying to be a minimalist I have a makeshift one that was ridiculed here
but when compared to pro gear is more accurate than anything from a
hardware sto A digital suitcase scale. I can torque a screw to
precisely 44 in-lbs. Not 42 or 46 but exactly 44. Try that with one of
those ratchet gizmos.
That tool can also accurately weigh bicycles and other unwieldy devices.
It has a sturdy loop with a click lock.
Alternately there might be sufficient material to drill and tap bolt
holes out to the next size, i.e., 5mm - 6mm.
There isn't but worst case I file it flat on the other side and place a
capped steel nut.
Another idea might be to see what the real racing boys are using for
stems and use the same. I doubt that a guy racing for a $750,000 first
prize (The winner of the Munga will take home $750,000, followed by
$100,000 for second, and $50,000 for third place ) plans on having
many problems with the stem on his bike.
I wasn't planning on spending $20k+ on a mountain bike.
--
Regards, Joerg
http://www.analogconsultants.com/