adam85 wrote:
Bleve Wrote:
For the archive, here's how to set Polar speed and cadence transmitter
power
output levels. AFAIK, this isn't documented in anything that Polar
distributes. I'll be taking photos and doing a better howto soon, but
for now,
this will do!

http://www.aboc.com.au/perl/tips.pl?p=polar_senders

It wasn't obvious but I found instructions on the pursuit performance
forums page.

http://www.pursuit-performance.com.au/polar/index.html

I changed my speed sensor to the strongest setting so it would work
with the watch setup midway along my TT bars. I haven't tried it with
the speed sensor on the rear wheel (for use on a trainer) but I was
only getting an intermittent signal with the strength on the middle
positions.

I've been running one on the max setting for years on my back
wheel. I haven't ever been able to find the jumper settings
on the Polar site, it's not in the PDF user manual anyway, which
is why I put it up somewhere easy to find, after getting the
cheese from the local Polar distributor.