icon wrote:

When I get around to making a uni[1], it'll all be much better designed
- properly machined bearing housings that extend the full circumference
of the bearing, less a couple of thou.

Regards
John

[1] Ha!



The 'KH' (http://www.krisholm.com) has this. Works really well. I
usually keep the bolts on my non-awesome bearing holders to a light
push on the end of a wrench that's screwing them on. Haven't had any
problems (too loose nor too tight) yet.


--
flyer
------------------------------------------------------------------------
flyer's Profile: http://www.unicyclist.com/profile/9894
View this thread: http://www.unicyclist.com/thread/48137