On 9/13/2018 7:29 PM, Joerg wrote:
On 2018-08-24 07:35, Joerg wrote:
Couldn't believe it. Those great agency folks obviously didn't test the
bike racks for our local buses before signing the contract. Long story
short my 29er bike didn't fit in and neither did my friend's. Luckily
the driver was patient and helpful. We had to load the bikes reversed so
the hook goes over the rear wheel. Not easy because of my panniers but
worked, somehow. The front wheels now rode up on the other side of the
rack slot. We both had bungee cords with which we strapped them down as
hard as we could. Oh, and the slot width barely fit my 2.25" wide MTB
tires barely squeezed in and I had to push down hard. The rack looks
like this:

https://ixquick-proxy.com/do/spg/sho...8df2678ec2064b



When we arrived another rider put his 26" MTB on there on even that
barely fit in (rear wheel rode up half an inch).

Does anyone know a better "strap down" method that is faster than
wrapping a bungee around rim and rack numerous times?


Today I did a road bike trip where I also used the bus. The bus had a
3-slot rack but only the innermost slot was designed correctly with one
end open.

The two outer slots were the same as before, bad design, too short. I
know that Jay and Sir won't believe this but I tried and verified it: My
road bike did _not_ go into those outer slots. Luckily the inner slot
was free.

So what is the wheelbase of your road bike? And what's the wheel size?

I'm curious how you always seem to end up on a remote tail of every bell
curve.


--
- Frank Krygowski