drill/tap in frames
On 7/7/2018 9:27 AM, Emanuel Berg wrote:
Are there any secrets to drilling holes in
steel bike frames? I have a couple of discarded
ones I can test on but I thought I'd
ask anyway.
Do you use normal power hand tools like
a drill-screwdriver and/or a drill press (if
possible with the desired bolt position)?
Do the normal rules apply, e.g. to get
a threaded hole for an M6, you first drill with
a 5.0mm drill?
And you can use chainsaw oil, right?
Subtract pitch from major diameter, e.g., tap drill for an
m5x0.8 is 4.2mm and use lard-sulphur cutting oil for
drilling and tapping in steel.
Yes use chainsaw oil on your chainsaw.
--
Andrew Muzi
www.yellowjersey.org/
Open every day since 1 April, 1971
|