On 11/30/2018 7:55 AM, Tanguy Ortolo wrote:
Hello all,

A couple of months have passed since I switched to wax for chain
lubrication. I would estimate I rode about 3,000 kilometers with my
chain (cleaning it and lubricating it four times, I think), a point at
which I usually start measuring at least some elongation.

In this case, I cannot measure any. 10 links span 254 mm ± .3 mm, so
that is less than 1 ‰ of elongation. My chain is a good as new. As an
additional bonus, my entire drivetrain has never been that clean!

Unfortunately, when I switched to chain waxing, I also changed from
Shimano chains to a KMC 9.73 one, so I cannot assert that waxing
is good for chain wear, only that either it is, or KMC chains are very
resistant, or both.

Anyway, now I think I will soon be at the point where I will have to
replace my cassette that is starting to be a bit worn, without changing
the chain that is still as good as new!

Did you use pure paraffin wax, or did you add any oil to the melted wax?

--
- Frank Krygowski