On 3/19/2018 1:47 PM, Emanuel Berg wrote:
Jeff Liebermann wrote:
What do you think guys, maybe this one is
a good choice?
https://www.youtube.com/watch?v=jML8nVSntuE
A good choice for doing what?
In another thread was the question, how do they
cut aluminium tubes so that they fit together
before welding, e.g. the top and down tube to
the head tube? And the answer is a
milling machine (and not a press drill).
I'm sure the Luna is a good choice for
"doing it" only the person who has to pay for
it might disagree
An easier question. Just ring up Andy Newlands:
http://www.strawberrybicycle.com/gal...hetti&id=ML314
http://www.strawberrybicycle.com/gal...hetti&id=ML317
--
Andrew Muzi
www.yellowjersey.org/
Open every day since 1 April, 1971