Paul Hobson wrote:
Hey everyone,
I just bought a front brake caliper that's *just* too short for the
Peugeot frame that it'll be one. Seriously, I only need another 1 mm of
reach...maybe 2 mm tops.
Does anyone see an danger to me filing a flat spot in the bolt like this:
http://sheldonbrown.com/images/sovos_flat_axle.gif ???
only it'd be on the brake pad's bolt...not my axle...you get the picture.
I've also thought about filing the caliper itself down just a hair since
there is a significant amount of material below the lowest point at
which the pads can sit. Does anyone see dangers to doing this? Keep in
mind I need only a little --||--- more room and the brakes are
/perfect/. Additionally, I'd like to avoid buying a new brake caliper as
I bought this one second hand and can't really return/exchange it (it's
also nice).
I assume the problem is the brake pad or shoe is contacting your tire?
I'd first consider extending the slot by 1 mm, as someone else
suggested.
Another possibility may be to shave 1 mm of rubber off the top of the
brake pad. That's five minutes work with a utility knife. The only
downside is microscopically faster pad wear.
- Frank Krygowski