|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Octalink V2 crank bolt question: Washers needed on both sides?
Just removed a shot BB and when taking off the bolts from the cranks I
found that the left side had a thin washer but the right side did not. Weird. The crank set is Shimano FC-M522. Is a washer needed on both sides? Is it steel? If so I'll probably have to make one. -- Regards, Joerg http://www.analogconsultants.com/ |
Ads |
#2
|
|||
|
|||
Octalink V2 crank bolt question: Washers needed on both sides?
On 2018-02-12 15:27, Joerg wrote:
Just removed a shot BB and when taking off the bolts from the cranks I found that the left side had a thin washer but the right side did not. Weird. The crank set is Shimano FC-M522. Is a washer needed on both sides? Is it steel? If so I'll probably have to make one. Well, I just made a washer for the other side. -- Regards, Joerg http://www.analogconsultants.com/ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shimano crank cinch bolt help needed | damyth | Techniques | 3 | July 16th 10 01:43 AM |
Self-Extracting Crank Bolt question | pkittle | Unicycling | 10 | November 16th 08 05:51 AM |
Octalink BB: Keep tightening left bolt, save a crank? | TomYoung | Techniques | 3 | October 22nd 06 05:49 PM |
WTB: FSA superlight cranks 172.5 for octalink bb 130 bolt pattern | [email protected] | Marketplace | 0 | May 3rd 05 03:26 PM |
Pedal washers? Needed or not? | TNyzio | Techniques | 5 | September 14th 04 09:48 PM |