#1
|
|||
|
|||
Threads
I'm replacing the "Force 40" brake on the back of my C'dale MTB. The bridge
has a hole for the cable stop/brake adjust and my brake adjuster is threaded and just a little too big to slip in. As I would like to use the brake adjust I need to tap the hole in the bridge. The threaded part of the brake adjuster measures 7 mm in diamter and has 6 threads in 5mm. Can anyone tell me which tap that needs? None of my "inch" taps are close. Thanks Tom Gibb |
Ads |
#2
|
|||
|
|||
TBGibb wrote:
I'm replacing the "Force 40" brake on the back of my C'dale MTB. The bridge has a hole for the cable stop/brake adjust and my brake adjuster is threaded and just a little too big to slip in. As I would like to use the brake adjust I need to tap the hole in the bridge. The threaded part of the brake adjuster measures 7 mm in diamter and has 6 threads in 5mm. Can anyone tell me which tap that needs? None of my "inch" taps are close. I just changed to V-brakes, which neatly sidesteps the problem! |
#3
|
|||
|
|||
TBGibb wrote:
I'm replacing the "Force 40" brake on the back of my C'dale MTB. The bridge has a hole for the cable stop/brake adjust and my brake adjuster is threaded and just a little too big to slip in. As I would like to use the brake adjust I need to tap the hole in the bridge. The threaded part of the brake adjuster measures 7 mm in diamter and has 6 threads in 5mm. Can anyone tell me which tap that needs? None of my "inch" taps are close. I just changed to V-brakes, which neatly sidesteps the problem! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BB Sizing question-- English threads and 70mm width? | Jim Rogers | Techniques | 3 | December 23rd 03 01:44 PM |
Spoke threads exposed on new wheel - Safe? | Dave S | Techniques | 51 | November 6th 03 07:28 PM |
Crank threads keep stripping | Jason | General | 2 | October 20th 03 05:05 AM |