|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Shifter cables - Whats out there ?
Looking for shifter cables (system = sleeve and cable)
Whats the smoothest or lowest resistance system available today off the shelf ? Or Should i keep the old sleeve (which has been in use for 1-2 years) and just replace the cable ? I dont use grease the cables - just wipe with light oil |
Ads |
#2
|
|||
|
|||
Shifter cables - Whats out there ?
On 3/9/2017 6:52 AM, ixiz wrote:
Looking for shifter cables (system = sleeve and cable) Whats the smoothest or lowest resistance system available today off the shelf ? Or Should i keep the old sleeve (which has been in use for 1-2 years) and just replace the cable ? I dont use grease the cables - just wipe with light oil Unless there is damage to the casing or you are tired of the color, new wires should do it. Take a close look at the various casing ends especially if there are any plastic ferrules which have an annoyingly high failure rate. -- Andrew Muzi www.yellowjersey.org/ Open every day since 1 April, 1971 |
#3
|
|||
|
|||
Shifter cables - Whats out there ?
"ixiz" wrote in message ... Looking for shifter cables (system = sleeve and cable) Whats the smoothest or lowest resistance system available today off the shelf ? Or Should i keep the old sleeve (which has been in use for 1-2 years) and just replace the cable ? I dont use grease the cables - just wipe with light oil You can get PTFE coated inners - black like a non-stick pan. Pretty good IME. Bedded in outers are better - less sharp edges to scrape the PTFE off the inner. So far I've only seen them on sale as sets/kits - the outer isn't coated, so if you see inners offered on their own - buy. |
#4
|
|||
|
|||
Shifter cables - Whats out there ?
On Thursday, March 9, 2017 at 3:53:05 PM UTC-5, Benderthe.evilrobot wrote:
"ixiz" wrote in message ... Looking for shifter cables (system = sleeve and cable) Whats the smoothest or lowest resistance system available today off the shelf ? Or Should i keep the old sleeve (which has been in use for 1-2 years) and just replace the cable ? I dont use grease the cables - just wipe with light oil You can get PTFE coated inners - black like a non-stick pan. Pretty good IME. Bedded in outers are better - less sharp edges to scrape the PTFE off the inner. So far I've only seen them on sale as sets/kits - the outer isn't coated, so if you see inners offered on their own - buy. Only until that coating starts to wear off the inner cable and gums up your shifting something fierce. Cheers |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
new cables, brake and shifter | Mark Cleary[_2_] | Techniques | 8 | June 17th 10 10:00 AM |
Keep Breaking Shifter Cables - Why? | Steve Sr. | Techniques | 19 | October 17th 09 02:16 PM |
Shifter cables routed under BB, ice? | Ron Hardin | Techniques | 6 | March 5th 07 05:06 PM |
Three Speed tob tube shifter cables?? | [email protected] | Techniques | 2 | June 14th 06 08:46 AM |
W.T.B. Nokon shifter cables | Goldy | Marketplace | 0 | October 29th 04 10:39 PM |