How do i get the inside of a Valve Extensioner out of a carbon rim? - Page 2 - CycleBanter.com

A Cycling & bikes forum. CycleBanter.com

		Home » CycleBanter.com forum » Regional Cycling » Australia
How do i get the inside of a Valve Extensioner out of a carbon rim?

Mark Forums Read

How do i get the inside of a Valve Extensioner out of a carbon rim?

« Previous Thread | Next Thread »

Page 2 of 2

2

#11

Old

March 9th 08, 11:26 PM posted to aus.bicycle

[email protected]

external usenet poster

Posts: 89

Default

How do i get the inside of a Valve Extensioner out of a carbonrim?

got it!!!!!!
Magnet drill bit, tweezers, and a spare spoke where the tools needed
for the job. 5 mins.

Report this post as spam, offensive or inappropriate

Reply With Quote

Ads

Page 2 of 2

2

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dual valve floor pump only pushes air out the Schrader valve hole	Brad Ford	Techniques	19	November 25th 18 04:15 AM
Air Inside Tire	[email protected]	General	14	December 21st 07 04:04 AM
Valve stems, SLIME sealant, and valve positions...	Scott Thomas	Techniques	3	April 13th 05 08:00 PM
Bikes inside SUV	FlashSteve	General	11	September 17th 03 01:57 AM

All times are GMT +1. The time now is 10:22 PM.