|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hayes Hydro Brake Lever Pivot servicing question
Hey group... although this newsgroup is usually rife with idle talk, the
occasional ride report, lots of OT, and the rare challenge/smack talk, I am banking on you guys to know something about Hayes hydro levers rec.bike.tech is full of practical people who would have no idea of hydros (as opposed to mechs). Anyways, here's my question: I replaced my brake lever pivots today, and it went very successfully and smoothly. There are two plastic bushings that go into the upper and lower part of the big gap spanning where the actual lever goes. Am I supposed to lube these bushings? They're plastic, so I'm thinking no, but the consensus is usually to lube everything. What about square tapers? Lube? *duck and run* Thanks, all. -- Phil, Squid-in-Training |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
disc brake question | N Grover | Mountain Biking | 16 | December 9th 03 06:43 AM |