|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
Battery Replacement on Lights with Internal Li-Ion Batteries
On 2018-02-08 16:52, Frank Krygowski wrote:
On 2/8/2018 3:08 PM, Joerg wrote: On 2018-02-07 07:01, AMuzi wrote: On 2/7/2018 12:06 AM, Tosspot wrote: On 07/02/18 03:56, Frank Krygowski wrote: On 2/6/2018 1:52 PM, sms wrote: My wife's Lezyne Deca 1500XXL stopped taking a charge, at all. Taking it apart, I saw that the batteries were made in July 2015. Not too good for it to stop working that soon. Some of my bikes have dynamos that are 30 years old. They just keep going and going and going... I bet the lights don't, as he peers at a collection of CYOs[1] and a recently defunct Flat-S. Tbf the Flat S is around 7 years old. [1] Not one lasted 18 months, they simply aren't waterproof imho. My regular glass bulb lamps go 6~8 years between bulb failure in daily use. YMMV Ye olde 2.4W + 0.6W with a dynamo? When riding at a good clip, meaning north of 15mph, those never lasted much longer than a month for me. Even if they didn't blow their filament right away the bulbs turned black inside and became dimmer than they were already to begin with. When I was a teenager I started equipping my bikes with what the automotive industry already understood over 100 years ago, brighter lights, a battery and charging system. Soon the German police wanted to give me a ticket for "non-standard" lighting. Luckily by that time I was a Dutch resident and they had to let me go. Those 2.4W bulbs were a joke. I think you missed about three generations of dynamo lighting technology. My first dyno had a vacuum bulb. It was terrible at lighting the road, but fine as a "be seen" light, better than the battery lights available at the time. Yes, the bulb blackened a bit after a while. That meant the bulb needed to be changed. And yes, it wasn't wonderful overall; but at that time (early 1970s) I knew of no really good bike light. You had to make your own, either using Krypton flashlight bulbs (expensive) or mofa lights. Mofas where the slow gas-popwered "bicycles" in Germany, limited to 25km/. Unless souped up which almost all my class mates who had one did. My next dyno set came with a krypton bulb. It was significantly brighter. See? You could buy those in the 70's, just not for 6V. Most of the ones I used on my bicycle were rated 3.7V. ... The optics of the headlamp were also a tiny bit better. This was better at lighting the road, but still not great. It was more than fine for a "be seen" light. (Contrary to modern myth, it takes very little light to be easily seen and noticed by other road users.) Incidentally, I don't think I ever burned out a bulb with either of those lights. But I didn't ride fast with either. I went through regular bike bulbs as if they were popcorn until I switched to better systems. When I eventually told my bike shop friend I wanted to see better, he sold me a Union lamp with a halogen bulb. This was my first headlamp that actually focused the light properly on the road. (It was StVZO compliant.) With that, I was finally able to see the road well enough for all the riding I did. And this headlamp had two zener diodes in the circuit, which pretty much cure the bulb-blowing problem. (Interestingly, after years of use, one of the zeners failed. But by then I had other headlamps to choose from as replacements.) The zener would also waste power. However, I found those lights way overpriced back then. So yeah, I skipped that halogen generation except for my desk lights. For a long time that was my setup but I was interested enough to do various experiments. I played with various battery lights, both commercial and homebrew, including a couple with external battery packs. I decided they offered minimal practical improvement over the dyno lights and were not worth the inconvenience. Most likely you didn't build them right. The best bulbs and reflectors were those from "tactical flashlights" or whatever they called them. The kind the police used when they were looking for someone. In those days they had a metal tube that held D-cells, which I cut off. They had Krypton bulbs or bulbs filled with other gases and the rated voltage was always substantially lower than the battery stack offered yet they lasted a long time. ... I learned that optics were key, and I learned that some headlamps had better optics than others. I compared dyno headlamps by mounting two of them, with a switch that allowed either one or both to be active. And BTW, those were mostly 2.4 Watt bulbs, although I tried a 3 Watt for a while. I also learned that some dynos produced a bit more power than others. .... and blew those bulbs. The experimenting ended when I bought my first Cyo. It became obvious to me that this produced more light than I needed, so I considered the problem solved. Later versions were even better. By now, I've had friends with other battery lights praise my headlight, saying (for example) "I want to ride next to Frank. His headlight is great!" The overall point is this: The vacuum bulb headlamp someone used in Germany in the 1970s has as much relation to current dyno light technology as a MIFA has to a Trek Madone. We were talking about Andy's light and that seems to be 70's era. http://www.telegraph.co.uk/men/think...-on-a-50-bike/ Oh man, I sure would not want to do that ride. -- Regards, Joerg http://www.analogconsultants.com/ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamo Lights viz Battery Lights in snow qand slush? | Sir Ridesalot | Techniques | 6 | March 4th 15 10:36 PM |
Cheap lights using CR123 batteries | Tom Anderson | UK | 3 | January 18th 11 02:33 AM |
Rechargable Cells/batteries for Lights | Keiron Kinninmont | Techniques | 8 | December 25th 06 11:58 PM |
Lights without batteries? | Steve Watkin | UK | 9 | May 16th 06 10:04 PM |
Rechargeable batteries with LED lights | David Ward | Techniques | 8 | March 17th 05 03:40 AM |