|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
PowerTap SL Lacing: 2X or 3X ?
The PowerTap SL manual reads in one place "[b]oth sides of the PowerTap
should be built using a 3x spoke lacing pattern" and in another place it reads "[u]se at least a two-cross pattern on both sides of the hub." Any recommendations about this or other tips about lacing with a PowerTap SL hub? Thanks. -- Daniel |
Ads |
#2
|
|||
|
|||
PowerTap SL Lacing: 2X or 3X ?
3X with 32 holes, 2X with 28 or less.
|
#3
|
|||
|
|||
PowerTap SL Lacing: 2X or 3X ?
Daniel Norton wrote: The PowerTap SL manual reads in one place "[b]oth sides of the PowerTap should be built using a 3x spoke lacing pattern" and in another place it reads "[u]se at least a two-cross pattern on both sides of the hub." Any recommendations about this or other tips about lacing with a PowerTap SL hub? Thanks. -- Daniel I think to prevent flange failure they are saying use 'at least 2 cross'...but use 3 cross, even on 28h, inside pulling would be best with such large flanges. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: Powertap Pro | [email protected] | Marketplace | 1 | September 22nd 05 02:00 AM |
FS: Powertap Pro CPU | John Verheul | Marketplace | 0 | August 3rd 05 06:09 PM |
FA: PowerTap + + + LAST DAY | Rod | Marketplace | 0 | April 23rd 05 01:38 AM |
FS: PowerTap Pro | gorobgo | Marketplace | 0 | January 4th 05 10:10 PM |
wtb: powertap | Michael Perlberg | Marketplace | 2 | October 7th 04 12:42 AM |