|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Question on installing Ultegra 6603 crank
Picked up a new 6603 crankset at a swap meet a while back, and am just
getting around to installing it, unless it is incomplete. It came without packaging and installation instructions. Shimano technical services instructions have a 6-step procedure to install. Step 6 says, in part: "Push in the stopper plate and check that the plate pin is securely in place, and then tighten the bolt ...." I don't have a stopper plate. Anybody know the function of this stopper plate? Is it just to prevent overtightening of the bolts? If so, a couple of washers probably would suffice? Thanks. KenW |
Ads |
#2
|
|||
|
|||
Question on installing Ultegra 6603 crank
kwalters wrote: Picked up a new 6603 crankset at a swap meet a while back, and am just getting around to installing it, unless it is incomplete. It came without packaging and installation instructions. Shimano technical services instructions have a 6-step procedure to install. Step 6 says, in part: "Push in the stopper plate and check that the plate pin is securely in place, and then tighten the bolt ...." I don't have a stopper plate. Anybody know the function of this stopper plate? Is it just to prevent overtightening of the bolts? If so, a couple of washers probably would suffice? Thanks. KenW It's a little plastic doohicky to prevent overtightening of the bolts...the last 6603 crank I installed last Wednesday(new in the box) didn't have it in there at all...just use a good torque wrench and adhere to the 10-15 n-m or whatever it says on the left crank arm. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
F/S: Shimano Ultegra 10s FD (model 6603) | Mariano pacini | Marketplace | 0 | May 19th 07 11:10 AM |
Re-Installing Ultegra Middle Chainring without Removing Crank | [email protected] | Techniques | 2 | April 23rd 07 01:31 PM |
Must use 10-Speed chain with Ultegra 6603 crank? | RS | Techniques | 9 | July 24th 06 01:46 PM |
installing and removing square taper crank multiple times | eflayer2 | Techniques | 4 | February 6th 06 11:56 PM |
Question on installing an ultegra casette | Bob Palermo | Techniques | 3 | June 20th 05 02:50 PM |