|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Presta valve in a rim that was drilled for Schrader?
Just received a new rear wheel. Despite being 700c and for narrow tires
the rim is drilled for a Schrader valve. Couldn't believe it. Harumph, grumble. Why on earth ... well, it is what it is. I don't want to wait for some fancy adapter but I do not mind making just about anything in the garage with hand tools. My special thick tubes have Presta valves. What should I use? Piece of plastic? Aluminum? Glue it in place? Anything needed on the outside except maybe a washer? -- Regards, Joerg http://www.analogconsultants.com/ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dual valve floor pump only pushes air out the Schrader valve hole | Brad Ford | Techniques | 19 | November 25th 18 05:15 AM |
Presta vs. Schrader | Joy Beeson | Techniques | 13 | July 4th 13 07:28 PM |
presta valve in a schrader wheel! | Mark Cleary[_2_] | Techniques | 9 | May 28th 10 07:16 AM |
Schrader? Presta? Bah! Elegant G&J valve | [email protected] | Techniques | 1 | March 3rd 10 11:34 PM |
Presta to Schrader | Mister2u | Techniques | 16 | September 8th 08 07:26 PM |