|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Looking 4 a new Wheelset
On 30 Oct 2005 19:52:45 -0800, "StaceyJ" wrote:
This will only work if your axle is long enough - I'd be worried about having enough exposed to properly engage the frame. You may find that You can get a new, longer axle for 10-20 bucks. you need to add spacers & then recenter the axle (requiring adjustment to both drive and non-drive bearings), and you'd still be pusing it. You'd be best served by using a hub designed for the 135 spacing (or cold setting your frame to fit the narrower hub). http://www.sheldonbrown.com/singlespeed.html#vertical : |I have been experimenting with a more drastic solution: on my Bianchi |Osprey, I have cut the rear axle short so that it doesn't protrude past |the surfaces of the locknuts. Thus, only the quick-release skewer goes |through the dropouts. Since the skewer is quite a bit thinner than the |actual axle, this gives me considerably more adjustment room. |If the skewer is properly tightened, the axle is held in place by the |friction of the locknuts being pressed against the inside of the dropouts. |If this were not the case, horizontal dropouts would not be usable, since |the forward pull on the chain creates a larger force against the axle than |supporting the rider's weight does. Just to be on the safe side, I am |carrying a spare skewer along with my spare tube. Jasper |
Ads |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FA: Velocity Spartacus Wheelset (Shimano) | [email protected] | Marketplace | 1 | March 22nd 05 01:06 PM |
Rebuilt Coker Wheelset vs. Airfoil Wheelset | oxfordrider | Unicycling | 18 | April 25th 04 07:10 PM |
What makes a $400 wheelset a $400 wheelset? | NLee1875 | Techniques | 22 | December 31st 03 11:37 PM |
FS - Shimano WH-7701 Dura Ace Wheelset + Extras... | basjan | Marketplace | 2 | December 28th 03 12:16 AM |
KH trials wheelset question | sabin_a. | Unicycling | 7 | December 5th 03 03:56 PM |