|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Disc Wheel Build Build Suggestions
Hello Cycling Forum, I am looking for additional suggestions/feedback regarding a disc whee set that I plan to build. Up to this point, I have always used straigh gauge spokes however, after reading Jobst Brandt's "The Bicycle Wheel I am compelled to use 14/15/14 swaged spokes. Please give me advic based on your experience using disc wheels laced with 14/15/14 spokes 13/15/14 spokes or straight 14 gauge spokes. Also, what kind o results have you had with 4-cross lacing and discs? The parts I have to use are as follows: 36-hole, ISO disc rear hub 32-hole, 20 mm ISO disc front hub Mavic D321 rims The rear wheel will be used with either a 6 or 8 inch rotor. The front wheel will be used with an 8 inch rotor. Thank you for your help. Regards, Jerem -- osobailo |
Ads |
#2
|
|||
|
|||
Osobailo- Please give me advice
based on your experience using disc wheels laced with 14/15/14 spokes, 13/15/14 spokes or straight 14 gauge spokes. Also, what kind of results have you had with 4-cross lacing and discs? BRBR Lace three cross, head out or 'inside pulling' and use 14/15 spokes, brass nipps. This is the set up we have used for a couple 'o dozen disc wheelsets. Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302 (303)440-3535 http://www.vecchios.com "Ruote convenzionali costruite eccezionalmente bene" |
#3
|
|||
|
|||
Osobailo- Please give me advice
based on your experience using disc wheels laced with 14/15/14 spokes, 13/15/14 spokes or straight 14 gauge spokes. Also, what kind of results have you had with 4-cross lacing and discs? BRBR Lace three cross, head out or 'inside pulling' and use 14/15 spokes, brass nipps. This is the set up we have used for a couple 'o dozen disc wheelsets. Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302 (303)440-3535 http://www.vecchios.com "Ruote convenzionali costruite eccezionalmente bene" |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help! Accidentally squeezed disc brake lever with no wheel... | justen | Mountain Biking | 14 | November 25th 04 12:41 PM |
Spoke Over-Tension and Drifting Wheel Alignment | mCrux | Techniques | 6 | August 25th 04 04:29 PM |
Perverse wheel build | Benjamin Lewis | Techniques | 25 | May 11th 04 04:56 AM |
Going to build a rear wheel! | TJ Poseno | Techniques | 14 | October 9th 03 05:03 AM |
Disc brake front wheel ejection: fact or fantasy? | John Morgan | Mountain Biking | 76 | September 8th 03 09:04 PM |