|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
campy ergo disassembly question
I've got a set of round-hood Mirage levers that have 1/2-1" of play in
the right finger lever before the shift click occurs. There also isn't very much tactile feedback when shifting this way. The thumb lever is fine and clicky (after I replaced the g-spring carrier a few months ago). I've got it torn down as far as I can but can't figure out how to get the lever pivot pin out so that I can get at the finger-lever assembly. Is there a trick to this? Should I just squirt some oil in there and realize that this is just the way Mirage's are? Thanks for any insight! Eric |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mix-&-Match (Shimano & Campy) Question | StaceyJ | Techniques | 9 | January 17th 05 07:29 PM |
WTB: broken 8sp 9 sp CAMPY ergo levers | CLKarr | Marketplace | 4 | October 16th 04 08:38 AM |
Campy ergo 10/Shimano Dura Ace 10 Rear Wheel Question. | Tom Nakashima | Techniques | 11 | August 11th 04 01:53 PM |
Campy Ergo Shifter - Rebuild or Upgrade? | Arthur Shapiro | Techniques | 7 | August 4th 04 06:30 PM |
WTB Campy 9 or 10 spd ERGO Shifters Must be 2002 or newer | johnfrmtx | Marketplace | 1 | January 24th 04 01:51 PM |