|
|
Thread Tools | Display Modes |
#15
|
|||
|
|||
Bus bike rack too short, how to strap in a bike quickly?
On 2018-08-24 12:01, Sir Ridesalot wrote:
On Friday, August 24, 2018 at 2:17:27 PM UTC-4, Joerg wrote: On 2018-08-24 10:11, Frank Krygowski wrote: On 8/24/2018 10:35 AM, Joerg wrote: Couldn't believe it. Those great agency folks obviously didn't test the bike racks for our local buses before signing the contract. Long story short my 29er bike didn't fit in and neither did my friend's. Luckily the driver was patient and helpful. We had to load the bikes reversed so the hook goes over the rear wheel. Not easy because of my panniers but worked, somehow. The front wheels now rode up on the other side of the rack slot. We both had bungee cords with which we strapped them down as hard as we could. Oh, and the slot width barely fit my 2.25" wide MTB tires barely squeezed in and I had to push down hard. The rack looks like this: https://ixquick-proxy.com/do/spg/sho...8df2678ec2064b When we arrived another rider put his 26" MTB on there on even that barely fit in (rear wheel rode up half an inch). Does anyone know a better "strap down" method that is faster than wrapping a bungee around rim and rack numerous times? I wouldn't fault the rack designer too much. Bikes come in such incredible variety it's tricky to design even stationary bike racks. And transit companies are seldom flush with funds. They can spend only so much to accommodate the one percent with unusual bikes. In this day and age 27-1/2" and 29" bikes hardly represent 1%. And yes, the designers are at fault. They should have tested or at least hold a design review with actual cyclists attending. In med-tech we are obligated to hold those and for good reasons. Also, as I wrote even a simple 26" MTB didn't fit completely, the rear wheel remained an inch above the rail floor. In my book that constitutes a thoroughly botched design. As to your question: I wonder if a velcro strap with rectangular ring might work. They're fast to install and surprisingly strong. See, for example: https://www.amazon.com/Reusable-Cabl...g=UTF8&s=a ht Thanks, but I do not trust plastic for this stuff. The Arno straps that Sir mentioned seem to be the ticket here. Of course, there remains the risk that a picky bus driver refuses to accept that mounting method and we'd be stranded. -- Regards, Joerg http://www.analogconsultants.com/ Around here the bus drivers don't mind the few seconds it takes to use a long Arno strap to secure the bike to the rack. I just loop the strap around the top tube of the bike and then around the bus rack and cinch the Arno strap tight. It takes just seconds and I usually have it done whilst other passengers are getting on or off the bus. Arno straps are really tough as are their buckles. I've never had an Arno strap fail nor its buckle even when being used in the dead of winter. I've had many a plastic buckle snap when being cinched in winter's cold. I'll have to cinch down the rim only because going over the frame won't prevent the bike from sliding out sideways. Reason is that with a 29er MTB one wheel rides on top of a slot rail end instead of down in the slot. Probably the straps are some sort of Nylon material so I should be able to cut one to 15" length and use a cigarette lighter to re-seal the cut strands so they won't unravel. -- Regards, Joerg http://www.analogconsultants.com/ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Roof-mounted bike rack: fork mount or whole bike? | Bob Weissman | General | 11 | July 4th 07 06:32 PM |
Usuing a Thule "Wheel Strap" on Yakima bike tray? | Pete Grey | Techniques | 10 | December 11th 06 08:01 PM |
How to mount a bike on a bike rack? | MiamiCuse | General | 9 | January 14th 06 09:19 PM |
Suggestion: Attaching rear bike rack to cycle WITHOUT rear rack mounts | Steven M. Scharf | General | 0 | April 22nd 05 06:48 PM |
FS: as-new Delta "Hunch-Rack" upright 2-bike trunk rack...$100 | w.a. manning | Marketplace | 0 | August 12th 04 01:59 AM |