#6
|
|||
|
|||
Chain Stretch
On Friday, September 15, 2017 at 8:21:14 PM UTC-7, John B. wrote:
On Fri, 15 Sep 2017 07:44:29 -0500, AMuzi wrote: On 9/15/2017 4:48 AM, John B. wrote: I've been thinking about chain wear, sometimes called chain stretch, and have done a bit of research on the subject. One method is to lay the chain on a flat surface and measure the wear over, perhaps 12 inches of chain length, from the head of one pin to another. But modern multi speed chains are a bit more complex then the old fashioned chains and the rollers on a modern chain are not supported by the pins but by protrusions on the inner surface of the inner links thus does the distance from roller to roller relate to distance from pin to pin? Another method is to ignore the pin to pin distance and simply measure the roller to roller distance using a chain gauge. But I have also read that when comparing roller to roller measurement to pin to pin measurement there is not necessarily a correlation, or in other words a pin to pin measurement might show one thing while the roller to roller might show a totally different wear pattern. In addition I read that in at least one case the roller to roller wear was not constant and varied from place to place in the length of the chain Brandt, I believe, wrote a treatise on chain measuring gauges and argued that nearly all of them gave an incorrect figure for wear, or perhaps, did it the wrong way. So the question is what is the best system to use to avoid unnecessary sprocket wear, assuming that sprockets cost more and are more trouble to change than chains. There seems to be three options. One, to use a ruler and measure from pin to pin. Two to use a chain tool and measure from roller to roller. Or three, to use some combination of the two. Or perhaps there is a fourth - ignore the whole thing as a tempest in a tea pot :-) Interrupted sideplate chain does indeed wear faster than full roller chain. However both economy of manufacture and side flex (for index shifting) are better with interrupted sideplates. Generally, chain wear is measured with enough tension to take up any slack, not merely laid out on a table. The outer plates are joined by the rivet. The innies float and exhibit wear. By measuring 24 rivets' worth of slop we can effectively get an expanded 'vernier scale' of the very small per-rivet clearance change. Since our functional aspect for chain-to-sprocket efficiency is pitch, a rivet-t-rivet measurement seems right to me and all our gauges here measure that. See section #8d.2 he http://www.faqs.org/faqs/bicycles-faq/part3/ Yup, Brandt (in all his glory :-) I've been using an 18" stainless scale (ruler) which assuming a 1% wear limit is 3/16". (old eyes need big marks :-) I recently came across another chain measuring scheme that seemed to make good sense. Simply pull on the chain at the front of the chain ring forwards to see how much it moves away from the sprocket teeth. That test shows more the wear on the sprockets than that on the chain. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Chain stretch - actual tech. | James[_8_] | Techniques | 22 | March 7th 13 12:34 PM |
chain stretch question | Mark Cleary[_2_] | Techniques | 16 | November 16th 09 03:32 PM |
Scary chain stretch | Alan Braggins | UK | 1 | December 17th 05 09:45 PM |
Does chain stretch really exist? | Ken Marcet | Techniques | 15 | March 5th 05 09:15 PM |
chain un-stretch? | larry english | Techniques | 2 | August 12th 03 06:41 PM |