|
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 28th 04, 09:27 AM
|
|||
|
|||
WTB: 90 degree, 90mm ext., 1" quill stem
I need a 1" quill type stem with a 90mm extension that comes off the quill
at 90 or +10 degrees. That is to say the extension should be perpendicular or slighty angled upward from the quill. Clamp diameter should be 1" [25.4mm] but 26.0mm is O.K. with a shim. Stems that angle downward from the quill need not apply. A picture would be nice. Thanks, Dan. brm at politesociety dot com 
|
| Ads |
|
#2
August 28th 04, 02:03 PM
|
|||
|
|||
|
brm- I need a 1" quill type stem with a 90mm extension that comes off the
quill at 90 or +10 degrees BRBR New Profile H2O stem-$40 plus shipping Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302 (303)440-3535 http://www.vecchios.com "Ruote convenzionali costruite eccezionalmente bene"
|
|
#3
August 28th 04, 02:03 PM
|
|||
|
|||
|
brm- I need a 1" quill type stem with a 90mm extension that comes off the
quill at 90 or +10 degrees BRBR New Profile H2O stem-$40 plus shipping Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302 (303)440-3535 http://www.vecchios.com "Ruote convenzionali costruite eccezionalmente bene"
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
