|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
No powder coating for aluminum?
Our ancient (1986) Cannondales could use some refinishing. The paint has
bubbled and chipped in places, exposing the aluminum. The bikes aren't grossly ugly, but they're far from pristine. I think the original paint is DuPont Imron, or some similar catalyzing paint. I was given information about a local place that does a good job with powder coating, and is not very expensive. But I got to thinking: The bikes are 6061-T6 if I remember right. And I think powder coating gets baked at a higher temperature than the aluminum did. I'm finding that T6 heat treatment involves about 350 degrees Fahrenheit, but powder coating uses about 400F. That makes this sound like a bad idea. Is there something I'm missing? -- - Frank Krygowski |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Powder Coating | [email protected] | Techniques | 25 | August 21st 17 01:44 AM |
powder coating aluminum frames | zencycle | Techniques | 3 | July 20th 07 12:08 AM |
powder coating | x1psh1x | Unicycling | 8 | March 27th 06 06:22 PM |
Powder coating a hub | ntappin | Unicycling | 7 | February 22nd 06 08:05 PM |
Powder Coating Cost | thayr | Unicycling | 5 | March 17th 05 08:48 AM |