|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
I am after an LED to compliment my Halogen bike lights.
Ideally to assist with the "be seen" factor - even during the daylight hours, not just night time. What is the general view on a good front light? Also looking for an additional, good rear light? Don't care if drivers thing I look like a Christmas tree - in fact thats what I want! It means they see me if they think that. Any recommendations are appreciated. Craig |
Ads |
#2
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
Gurrie wrote:
I am after an LED to compliment my Halogen bike lights. Ideally to assist with the "be seen" factor - even during the daylight hours, not just night time. What is the general view on a good front light? Also looking for an additional, good rear light? Don't care if drivers thing I look like a Christmas tree - in fact thats what I want! It means they see me if they think that. Any recommendations are appreciated. I haven't used all 'that' many but I do really like VistaLite Eclipse for a rear flasher (probably hard to get now with the VistaLite distributor issues) and the S-Sun or similar 3-LED front light. $30 and $40 respectively. hippy |
#3
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
"Gurrie" wrote in message ... I am after an LED to compliment my Halogen bike lights. Ideally to assist with the "be seen" factor - even during the daylight hours, not just night time. What is the general view on a good front light? Also looking for an additional, good rear light? Don't care if drivers thing I look like a Christmas tree - in fact thats what I want! It means they see me if they think that. Any recommendations are appreciated. Craig I got one of those Xenon strobe lights. There's one he http://cgi.ebay.com/ws/eBayISAPI.dll...m=7151364 272 &rd=1 Bloody bright! If they can't see this, they shouldn't be driving. I use this as the rear, a flashing 3 LED light in front, a flashing LED on my backpack, two Knog lights velcroed to my helment (one flashing, one steady). All these are so I'm seen. I use a Cateye Opticube to see with (adequate, not great). I also use a Kathmandu Illumi Nite backpack; the reflective fabric works well. I have several bits of reflective tape on my frame too, as well as those Knog handlebar-end lights. Despite all this, I still get too many "Geez! I didn't see you!"s. I think it's that when non-riders are driving cars they look for other cars, motorcycles and peds. The "normal" things on the road. There are not enogh of us to be one of the normal things so we slide under the attention radar. Best it to be well lit, but don't put your faith in your equipment to keep you safe. Pay attention to yourself and every other bugger. The drivers who think you look like a Christmas tree aren't the ones you need to worry about - they've seen you. It's the blinkered buggers who don't see you no matter what you do that'll get you. Cheers, Frank |
#4
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
Plodder Wrote: Despite all this, I still get too many "Geez! I didn't see you!"s. think it's that when non-riders are driving cars they look for other cars, motorcycles and peds. disagree, just for cars & bigger -- aeek |
#5
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
"aeek" wrote in message ... Plodder Wrote: Despite all this, I still get too many "Geez! I didn't see you!"s. I think it's that when non-riders are driving cars they look for other cars, motorcycles and peds. disagree, just for cars & bigger. -- aeek Yeah... you're prolly closer to right than me. How about: High on radar - cars and bigger Mid radar - motorcycles Low on radr - peds Just about off the radar - bikes Frank |
#6
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
Gurrie Wrote: snipparge ... Any recommendations are appreciated. Craig if its for the 'be seen' factor, consider... I place 2 of them small LEDs with fast-flash setting on the front of m helmet and a red on the rear. These compliment my 5/10W cateyes(front) and another 3-light on m back. The ones on the front of your helmet are great, cos you can direct the AT drivers wanting to pull out of sidestreets, peds, etc and with 2 o em flashing out of sync its almost impossible to ignore em. Cos they are attached by their simple elastic/strap bittie with slipknot thru the vents in my hemet they are easy to remove/chang bikes (and the big meanies at Glenvale would larf at me ) Also big advantage in traffic as the light isnt obscured/hidden b cars next to you. Raising youre head or 'standing' means those pesk righthand-turners can see you over the car next to you, etc. They also have a rahter disco affect on all street signs, lighting e up like xmas trees. Anyone behind you WTF is going on and gets yet another way of noticin you too. AND they freak dogs out big time cost? approx $15each and battery life is good ( approx 3 monthly an $3each to replace -- flyingdutch |
#7
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
flyingdutch wrote:
I place 2 of them small LEDs with fast-flash setting on the front of my helmet and a red on the rear. These compliment my 5/10W cateyes(front) and another 3-light on my back. The ones on the front of your helmet are great, cos you can direct them AT drivers wanting to pull out of sidestreets, peds, etc and with 2 of em flashing out of sync its almost impossible to ignore em. Cos they are attached by their simple elastic/strap bittie with a slipknot thru the vents in my hemet they are easy to remove/change bikes (and the big meanies at Glenvale would larf at me ) Also big advantage in traffic as the light isnt obscured/hidden by cars next to you. Raising youre head or 'standing' means those pesky righthand-turners can see you over the car next to you, etc. They also have a rahter disco affect on all street signs, lighting em up like xmas trees. Anyone behind you WTF is going on and gets yet another way of noticing you too. AND they freak dogs out big time cost? approx $15each and battery life is good ( approx 3 monthly and $3each to replace) I like your dual helmet beam setup. I found a single X-Lite to be quite insufficient but I also wasn't going to spend $8 (yes, yuppie scum Hawthorn prices!!) to replace a single X-Lite's batteries every three months. That's good beer money!! A while after the first battery swap in my X-Lite, it died. I thought I was careful with the rubber water seal but perhaps not careful enough? http://www.thehippy.net/nucleus/index.php?itemid=148 hippy "jibber jabber" |
#8
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
Thanks for all the advice guys.
I was digging around and found some old rectangle shaped VistaLite flashers. Anyone had any experience upgrading the LEDs in them? Jaycar carry some retina buring 20,000mcd LEDs which I'd love to try. Just not sure if it would work and what resisitors to add etc. "hippy" wrote in message ... flyingdutch wrote: I place 2 of them small LEDs with fast-flash setting on the front of my helmet and a red on the rear. These compliment my 5/10W cateyes(front) and another 3-light on my back. The ones on the front of your helmet are great, cos you can direct them AT drivers wanting to pull out of sidestreets, peds, etc and with 2 of em flashing out of sync its almost impossible to ignore em. Cos they are attached by their simple elastic/strap bittie with a slipknot thru the vents in my hemet they are easy to remove/change bikes (and the big meanies at Glenvale would larf at me ) Also big advantage in traffic as the light isnt obscured/hidden by cars next to you. Raising youre head or 'standing' means those pesky righthand-turners can see you over the car next to you, etc. They also have a rahter disco affect on all street signs, lighting em up like xmas trees. Anyone behind you WTF is going on and gets yet another way of noticing you too. AND they freak dogs out big time cost? approx $15each and battery life is good ( approx 3 monthly and $3each to replace) I like your dual helmet beam setup. I found a single X-Lite to be quite insufficient but I also wasn't going to spend $8 (yes, yuppie scum Hawthorn prices!!) to replace a single X-Lite's batteries every three months. That's good beer money!! A while after the first battery swap in my X-Lite, it died. I thought I was careful with the rubber water seal but perhaps not careful enough? http://www.thehippy.net/nucleus/index.php?itemid=148 hippy "jibber jabber" |
#9
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
Gurrie Wrote: Thanks for all the advice guys. I was digging around and found some old rectangle shaped VistaLit flashers. Anyone had any experience upgrading the LEDs in them? Jaycar carr some retina buring 20,000mcd LEDs which I'd love to try. Just not sure if it would work and what resisitors to add etc. [/color] Havent had experience with that light but have done some fairly untid hacks to the el cheapo $1.50 blinkies. First problem I found was that the( Jaycar, and all I think) 20,000mc Leds operate from 3.4 volts and the ones fitted were much lower voltag so "no go". No 1 for 1 swap. Then the IC to give the Blink is a special low voltage job so cant hac that! So, forget the blink, cut a piece of veroboard same size as PCB, moun 3 x 20,000mcd Leds (parallel), wire up sub minature toggle switch hack, file, nibble, hot melt glue gun. It works! Could have got all techo and used a low voltage cmos 7555 timer IC an a fancy sub minature rotary switch to give the blink but wanted it NO not in 12 months. No resistor required as its a 3 volt supply and leds operate at 3.4v just rely on internal resistance of leds. Wouldnt use more than 3 led in parallel as variations in internal R can cause problems apparently. Bloody bright but will slowly get dim as batteries go flat. Batterie last me about 6 months of riding 5 nights a week for just under hours. Cheers Hug -- HughMann |
#10
|
|||
|
|||
Best "Be Seen" LED Light? Front and Rear?
HughMann Wrote: Havent had experience with that light but have done some fairly untid hacks to the el cheapo $1.50 blinkies. First problem I found was that the( Jaycar, and all I think) 20,000mc Leds operate from 3.4 volts and the ones fitted were much lower voltag so "no go". No 1 for 1 swap. Then the IC to give the Blink is a special low voltage job so cant hac that! So, forget the blink, cut a piece of veroboard same size as PCB, moun 3 x 20,000mcd Leds (parallel), wire up sub minature toggle switch hack, file, nibble, hot melt glue gun. It works! Could have got all techo and used a low voltage cmos 7555 timer IC an a fancy sub minature rotary switch to give the blink but wanted it NO not in 12 months. No resistor required as its a 3 volt supply and leds operate at 3.4v just rely on internal resistance of leds. Wouldnt use more than 3 led in parallel as variations in internal R can cause problems apparently. Bloody bright but will slowly get dim as batteries go flat. Batterie last me about 6 months of riding 5 nights a week for just under hours. Cheers Hugh Any chance you could draw a diagram of this Hughmann? preferably in such a way that an idiot like me can decioher? cheers F -- flyingdutch |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Q: Chain noisy on front big ring/all rear cogs, silent on front small/all rear cogs | App | Techniques | 6 | October 12th 05 02:01 PM |
Rec.Bicycles Frequently Asked Questions Posting Part 1/5 | Mike Iglesias | General | 4 | October 29th 04 07:11 AM |
New bicycle idea | Bob Marley | General | 49 | October 7th 04 05:20 AM |
ICYCLES Inventory List | ICYCLES | Marketplace | 0 | July 26th 03 08:25 PM |
Braking Technique | asqui | Racing | 55 | July 25th 03 04:16 PM |