#1
|
|||
|
|||
Spinergy SR-3's
I'd like to open a rear wheel of these to inspect the pawls and
re-lube/re-grease them. I don't know yet how strong the pawl springs are and if they like oil or light grease. Does anyone know who makes these hubs for Spinergy. They look kind of like older HED hubs, which were Swiss made as well I think. I need to find some instruction for a little piece of mine. Thank you very much, Bill Graham |
Ads |
#2
|
|||
|
|||
Spinergy SR-3's
Bill- I'd like to open a rear wheel of these to inspect the pawls and
re-lube/re-grease them. I don't know yet how strong the pawl springs are and if they like oil or light grease. BRBR Oil onto pawls, particularly two pawl systems... Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302 (303)440-3535 http://www.vecchios.com "Ruote convenzionali costruite eccezionalmente bene" |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Spinergy X-Beams | Don Smith | General | 1 | September 14th 03 11:14 PM |