|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Donald- The "Record"
bottom brackets were also used for the 144 bcd triple cranksets up through 1977 with the Nuovo Record Triple. Read more about it here : BRBR Actually, last year for 144mm BCD cranks, via SuperRecord was 1987. 50th anniversary was introduced in 1983, same year Tullio died. Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302 (303)440-3535 http://www.vecchios.com "Ruote convenzionali costruite eccezionalmente bene" |
Ads |
#13
|
|||
|
|||
"Phil Brown" skrev i en meddelelse ... Well, yes and no.... The Older Record BBs did not have the internal reverse threads and they will only work with Old Record spindles. The later Nuovo Record BBs had the internal reverse threads and they will only work with the Nuovo Record spindles. Whichever set you try to use will give the same problem, which is due to the fact that the English BB shell was a bit too narrow. I wonder what "standard" it conformed to? Old 65mm shell. The Record (track) 65P110 spindle is still in catalog no.17. Michael You can use any cup with any spindle even though they may not be "correct" for each other. Some BB/chainline problems can be solved that way. Phil Brown |
#14
|
|||
|
|||
On Sun, 26 Dec 2004 12:41:14 +0100 "Waal" wrote:
Whichever set you try to use will give the same problem, which is due to the fact that the English BB shell was a bit too narrow. I wonder what "standard" it conformed to? Old 65mm shell. The Record (track) 65P110 spindle is still in catalog no.17. Thanks, having never paid much attention to track stuff, I was never aware of that, but, sure enough, there it is. Hmmm, 65mm, interesting. OTOH, I went downstairs and measured one of my Davis Components cast bottom bracket shells, and they measure 67mm, or 2-5/8". My Jackson frames are out in the cold right now and are hard to get to, but 2-5/8" is what my rather imperfect memory tells me they were. So I'm still guessing that this was some oddball inch dimension British standard that was about as close to 68mm as they could bring themselves to be. - ----------------------------------------------- Jim Adney Madison, WI 53711 USA ----------------------------------------------- |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: Vintage Campy and More | GNbikes | Marketplace | 0 | November 2nd 04 12:20 AM |
FA - Less Than One Day Left - Vintage Campy Crank/Chainset - 170mm- Drilled 52 x42 Rings | David White | Marketplace | 0 | August 16th 04 03:03 AM |