|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
copper anti-seize 3
the BB un-fixed cup turned out so i pulled the alum crank from the
steel 3S spindle. the copper went on four weeks ago and a 4 week monsoon ensued giving the copper a test. crank pulled easy, spindle shows no rust, and remaining rust pits on the 3S taper were black but mostly empty holes. i did run linseed onto the inner crank/spindle surfaces after the locktite setup in 3-4 days. that's superior short term result to the aluminum anti-seize in the rust/pull areas |
Ads |
#2
|
|||
|
|||
copper anti-seize 3
heat tube before using-hot sun ect copper ingreedyant disperese thru
carrier more evenly when hot possible also that a hot virgin tube will not cause fluid seperation problems |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anti French | [email protected] | Racing | 32 | July 7th 05 03:29 PM |
copper anti-seize 2 | [email protected] | Techniques | 8 | April 9th 05 09:01 PM |
RR: Copper Canyon, Mexico (Very Long) | Ride-A-Lot | Mountain Biking | 61 | March 19th 05 03:11 AM |
copper or aluminum anti-seize? | [email protected] | Techniques | 14 | February 10th 05 11:41 PM |
copper slip and aluminuim frames with parts | panda | Techniques | 5 | December 1st 03 07:58 PM |